marvin-miller
Arrrr...
Hi Folks;
I was just cheking over my Laser hull and I noticed gelcoat cracks in one area. I then pushed on it a bit and found that it's a little soft. I have no doubt that this was caused by my previous trailering method (tightenting the straps down extra tight because they would come loose). The soft spot is right in that area.
The thing is, the soft spot is right below the inspection port I just installed to repair the mast step. This brings me to a question....
If I laid a bunch of fiberglass cloth on the coorepsponding area inside the hull would this help firm it up?
I was just cheking over my Laser hull and I noticed gelcoat cracks in one area. I then pushed on it a bit and found that it's a little soft. I have no doubt that this was caused by my previous trailering method (tightenting the straps down extra tight because they would come loose). The soft spot is right in that area.
The thing is, the soft spot is right below the inspection port I just installed to repair the mast step. This brings me to a question....
If I laid a bunch of fiberglass cloth on the coorepsponding area inside the hull would this help firm it up?